My Cousin Vinny hysterical comedy bit, and the awesome positraction Tempest defense

Vinny Gambini: Maybe you didn't twist it hard enough.
Lisa: I twisted it just right.
Vinny Gambini: How could you be so sure?
Lisa: [sighs] If you will look in the manual, you will see that this particular model faucet requires a range of 10 to 16 foot-pounds of torque. I routinely twist the maximum allowable torquage.
Vinny Gambini: Well, how could you be sure you used 16 foot-pounds of torque?
Lisa: Because I used a Craftsman model 1019 Laboratory Edition Signature Series torque wrench. The kind used by Caltech high energy physicists. And NASA engineers.
Vinny Gambini: Well, in that case, how can you be sure THAT's accurate?
Lisa: Because a split second before the torque wrench was applied to the faucet handle, it had been calibrated by top members of the state AND federal Department of Weights and Measures... to be dead on balls accurate!
[She rips a page out of a magazine and hands it to him]
Lisa: Here's the certificate of validation.
Vinny Gambini: Dead on balls accurate?
Lisa: It's an industry term.
Vinny Gambini: [tosses paper away] I guess the fucking thing is broken.


Lisa: The car that made these two, equal-length tire marks had positraction. You can't make those marks without positraction, which was not available on the '64 Buick Skylark!
Vinny Gambini: And why not? What is positraction?
Lisa: It's a limited slip differential which distributes power equally to both the right and left tires. The '64 Skylark had a regular differential, which, anyone who's been stuck in the mud in Alabama knows, you step on the gas, one tire spins, the other tire does nothing.
[the jury members nod, with murmurs of "yes," "that's right," etc]
Vinny Gambini: Is that it?
Lisa: No, there's more! You see? When the left tire mark goes up on the curb and the right tire mark stays flat and even? Well, the '64 Skylark had a solid rear axle, so when the left tire would go up on the curb, the right tire would tilt out and ride along its edge. But that didn't happen here. The tire mark stayed flat and even. This car had an independent rear suspension. Now, in the '60's, there were only two other cars made in America that had positraction, and independent rear suspension, and enough power to make these marks. One was the Corvette, which could never be confused with the Buick Skylark. The other had the same body length, height, width, weight, wheel base, and wheel track as the '64 Skylark, and that was the 1963 Pontiac Tempest.
Vinny Gambini: And because both cars were made by GM, were both cars available in metallic mint green paint?
Lisa: They were!